Feeding too rapidly might stop the drill motor, cause the belt or drill to slip, or tear the workpiece loose craftsman and break the drill bit.
Loosen drill the nut (2) on the locking pin to the outside END OF threads.
As we said, the two materials used press for the construction of this drill press are metal and plastic, which is quite common for the press drills in inch this price category.Remove the drill press fence when it interferes with other driti press accessories.For small pieces that cannot be clamped to the table, use a drill press vise (optional accessory).When using craftsman drill a drill press vise, always fasten it to the table. Withtheswitch cabbage "OFF patch o penthejawsofthechuckas wide aspossible b yturning thechuck counterclockwise.
Lift the cover with the handle to reveal the motor and spindle pulleys, and drive.
Turn the motor switch "OFF and put away the switch key when leaving the drill press.
Tilting THE table (figure CC note: The table and support (1) has a predrilled hole with a locking pin inserted for locking the table into a predetermined 0 horizontal position.The Craftsman 10 features a 1/2 HP engine patch thats fast and powerful enough to deal with all kinds of soft and hard materials.They do have a few complaints, though such drill as the short warranty saga or the fact that the laser is powered by AA batteries).To avoid injury from inch parts thrown by the spring, follow instructions exactly when adjusting the spring tension of the quill.To keep the back-up material from spinning out of control, it must contact the left side of the column.Page 12 12, adjustments.1, To use the table in a bevel (tilted) position; tighten the nut (2) on the locking pin clockwise to release it from the table support.We also liked the units, lED light (allows working in darkness retractable laser light system (for patch higher accuracy as well as the insert mounts that enhance the stability.Always place a back-UP material (scrap wood) on the table beneath the workpiece.Tapthechuck(1)lightlywitha plastic saga tipped hammer atthetopofchuck, untilthechuck releases.Basic operatnON, instructions, to get the best results and minimize the likelihood of personal injury, follow these instructions for operating your drill press.
The 1/2 HP motor of this press drill produces enough torque to allow working with craftsman 10 inch drill press manual a wide array of materials, from plywood to metal.
The workpiece may unexpectedly shift, or your hand could slip.
Increase supply wire size or eliminate using an extension cord.